Wood Slice Plant Stand

I may or may not have a stash of wood slices. I don’t go to craft stores often but I am always tempted to grab one of these every time I do go. I have a lot of projects in mind but I just haven’t gotten to them yet. I did scratch one off of my list last month though! This project was originally share on Angie’s List website. I started freelance writing for them a couple of months ago. I loved this project so much I wanted to share it here as well.

 

 

I love mixing rustic items with modern or unexpected items. I knew this plant stand needed some glamorous gold legs!

 

 

 

I bought some tapered legs from Home Depot but I decided they were a bit too long for this so I cut off a few inches which made them slightly less tapered. If I were to do this again I would have gone ahead and bought the 4 or 5 inch legs to begin with.

 

I sprayed them with my new favorite gold spray paint.

 

 

And I added some furniture leg pads since it would be going on my hardwood floors.

 

 

Since the wood slice was not sealed, I added some polyurethane. I ended up doing 3 coats.

 

 

I drilled holes on the bottom for the legs. Drill holes that are slightly smaller than the screw part.

 

 

It really was just that simple! I think it would be pretty to make three that were different sizes and heights to group together.

 

PIN for later:

 

What projects did you get done over the weekend? Or were you lazy and binge watched Call The Midwife like me? :)

 

 

 

 

.