I am excited to be partnering with 3M DIY to share a tutorial on how to make a simple table.
I needed an entryway table (for reasons I will disclose later!). I shopped around at thrift stores, online yard sales, and at regular retail stores. I couldn’t find a simple table and I couldn’t find one for less than $50. I had a lot going on and wasn’t sure I wanted to tackle building one but then I realized I could use the same basic ideas as my simple side table and just adjust the measurements. I already had some of the wood and so I went for it!
Here is what you will need…..
Originally I was going to make it taller (the size of legs shown in picture) but them realized the proportions would be a bit off so I cut them a little bit shorter. The beauty of building your own furniture is you get to decide the size! I cut the 1×4 boards and the 2×2 boards on my mitersaw.
Before I nailed, I used wood glue.
I chose to do a butt joint but you could also do a mitered joint. See this post for pictures of the difference.
After I had the two sides and the front and back all nailed together, It was time to attach the legs. It is very important to make sure your legs are exactly the same length so your table will be stable. Also, use a level before gluing and nailing the legs into each corner.
The top of the leg should be flush with the top of the base. If it sticks up your table top will not attach properly.
Fill any nail holes with 3M™ Wood Filler . Let it dry and then sand it smooth.
I chose to stain both the base and the top before attaching the two together. You can always stain them after. I used Minwax® Early American.
I am going to detour a little bit and give a little public service announcement. PLEASE use a wood conditioner before staining especially if you are using a soft wood like pine. The stain will absorb differently at different places without the conditioner and come off very splotchy. I was going for “rustic” but rustic is different than splotchy :)
I stained the inside of the table to show as an example. This is the same board you will see the front of on the finished table. And look at the difference! If you use an oil based stain, use and oil based conditioner. If you use a water based stain, use a water based conditioner.
Alright, moving on….
Once the stain was completely dry, I attached the top.
I let the glue dry for a bit before decorating the table.
I did not seal the table with polyurethane like I normally would. I will explain later in another post. But after staining, you should seal the wood with your choice of wood sealer.
I love this color! It matches perfectly with all the Fall things I gathered. I am normally a Dark Walnut person but I am glad I tried something else this time.
I am proud to be a 3M- sponsored blogger, and, as part of my responsibilities, I get the opportunity to evaluate products from 3M DIY. Opinions are my own and additional product used in the project were selected by me.
You will also like: